Hotend Kit per stampante 3D Anycbic Kobra 3, blocco riscaldante assemblato con dissipatore di calore, testina di pressione, Hot End Kit con 2 ugelli in ottone da 0,4 mm per Kobra 3, Kobra 3 Combo

Alles Super. Schnelle Lieferung und alles wie Beschrieben.

tested this out on several hours of prints - works fine, no complaints. like all the variants of these hot ends, it was easy to install and swap out on the kobra 3 (only two wires to connect and the little flip switch at the top).

When I used this hot end, I couldn't tell the difference between tis one and one of the Anycubic originals I had.I have been trying out this hot end for a couple of weeks now on my Kobra 3 Combo, and it has been brilliant. Once installed it was just a matter of relevelling and I was up and running. I have been getting great print results with this unit printing a combination of PLA, silk PLA and PETG, and it just works. I also feel better knowing it has a hardened steel nozzle fitted, which should mean that the nozzle should have a nice long life.Overall, this does as good a job as the original one, and that can only be a good thing.

just realized I only got 1 nozzle extra.. and 1 steel nozzle installed.. but installed it.. and it wouldn't work unless wires were held a certain way. Then it would stop heating at time and give an error about wires on the printer. Also started to leak on top of the heatblock. Sorry seller but I wouldn't recommend this for Kobra 3.

Conforme à l'origine mais je n'es pas eux les deux têtes en plus